Models › Kitchen
Kitchen
Under-Cabinet Paper Towel Holder
A counter-standing roll takes space and gets knocked over. Mounted under a cabinet it is out of the way and easier to tear one-handed — which needs a small amount of friction on the roll, otherwise the whole thing unwinds when you pull.
Fits: Standard kitchen rolls up to 250 mm wide
Make this one yours. Cadio generates it to your measurements — change the size, slot count, or angle by describing what you need.
Customize in Cadio →Key dimensions
| Roll width | Up to 250 mm |
| Core diameter | 40 mm axle |
| Arm drop | 60 mm below the cabinet |
| Screw holes | 4 mm, countersunk |
| Friction | Sprung arm for one-handed tearing |
Print settings
| Material | PLA is fine, PETG if above a hob |
| Layer height | 0.2 mm |
| Walls | 3 perimeters |
| Infill | 20% |
| Supports | None |
| Orientation | Mounting face on the bed |
What actually matters
- Some friction on the axle is what makes one-handed tearing possible. A perfectly free-spinning roll just unspools.
- Check screw length against the cabinet base thickness before drilling — coming through the shelf above is a common mistake.
- Mount it near the front edge. Too far back and you cannot see how much is left.
Questions
Does it work with any roll size?
Most kitchen rolls fit. Extra-wide rolls need a longer axle — generate it to your measurement.
Can I mount it on a wall instead?
Yes, but the arm geometry changes. Generate a wall-mounted version rather than adapting this one.
Need it in a different size, or with more slots?
Generate your version →